Infocenter Diagnostics - Toro Reelmaster 5010-H Diagnostic Manual
Hide thumbs
Also See for Reelmaster 5010-H:
- Service manual (335 pages) ,
- Operator's manual (128 pages) ,
- Installation instructions manual (12 pages)
Table of Contents
Advertisement
2.
If the voltage that you measure is higher or lower than the specified voltage, clean and inspect the terminal
connections along the circuit path that you are testing.
Cleaning the Electronic Components and Connections
Note:
Use electrical-contact cleaner only. Do not use brake cleaner, as it may permanently damage electrical
connector bodies and other plastic components of the machine. Avoid using mineral solvents, as they may
damage connectors, seals, and wire insulation.
WARNING
Cleaning chemicals and tools can cause injury if used improperly.
Refer to the applicable MSDS for appropriate personal protective gear, such as gloves,
respirators, and safety glasses.
1.
Mark the wires for proper installation after cleaning is completed. Remove pins from connectors with the
proper extraction tool.
2.
Clean the terminals or the connector pins using an eraser, mild abrasive paper, or a nylon or fiber bristle
brush. Do not use metal or metal oxides.
3.
Finish the cleaning with a fiber bristle brush dipped in isopropyl alcohol.
4.
Gently wipe off the clean pins, terminals, and components with a lint-free cloth dampened with isopropyl
alcohol.
5.
When available, dry the components with dry, oil-free compressed air with a pressure no more than
138 kPa (20 psi).
6.
Ensure that all connectors and components are clean and dry prior to reassembly and testing.
InfoCenter Diagnostics
The InfoCenter Diagnostics screen displays the current status of various machine electrical components and
battery voltages
(Figure
Note:
The InfoCenter on the machine is sometimes referred to as the mini-InfoCenter (MIC).
1. Indicator light
2. Right button—press it to open a menu when a right arrow
indicates additional content.
To find additional information on navigating the InfoCenter menu items, refer to the 5010-H Service Manual,
InfoCenter Display section, or the 5010-H Operator's Manual, using the InfoCenter LCD Display section.
2). Use the Diagnostics screen to test machine switches and controls when possible.
Figure 2
3. Middle button—press it to scroll down the menus or digits
for PIN code.
4. Left button (menu access/back button)—press it to access
the InfoCenter menus. Also use it to back out of any menu
that you are currently using.
13
g020650
Advertisement
Table of Contents
Troubleshooting
