3.
Use the Toro DIAG software to reprogram the machine in accordance with Toro DIAG User's Guide. The
replacement cutting reel motor is programmed during the reprogramming of the machine.
4.
Disconnect the Toro DIAG cable from the machine.
5.
Install the access panel onto the outer cover of the control arm.
6.
Go to
Returning the Machine to Service (page 22)
Component Location and Electrical Connections
Cutting reel motor 4 is located in the front, left position. There are 2 electrical connections to the cutting reel
motor: P48 (4 wire) and P49 (2 wire).
and follow the steps listed.
301