Toro Reelmaster 5010-H Diagnostic Manual page 265

Hide thumbs Also See for Reelmaster 5010-H:

Table of Contents

If one or more of the power and ground wiring tests failed, repair or replace any worn or damaged parts.

Returning the Machine to Service (page 22)

Component Location and Electrical Connections

Cutting reel motor 3 is located in the rear, right position. There are 2 electrical connections to the cutting reel

motor: P40 (4 wire) and P41 (2 wire).

and follow the steps listed.

Connector Graphic

Troubleshooting