Location
Harness
1
Main
2
1
Main
2
Pass
The CAN bus wiring tests passed. Go to Step 3.
Fail
One or more of the CAN bus wiring tests failed. Repair or replace the worn or damaged parts. Go to
Returning the Machine to Service (page 22)
Step 3: Remove the motor/generator assembly from the machine.
1. Operator's seat
2. Motor/generator connector P37
Remove the motor/generator assembly from the machine. Refer to Chapter 5 of the 5010-H Service Manual.
See
Figure
167.
Pin
Connector
P37
5
Chassis ground
P37
6
Chassis ground
Wire
Expected
Color
Reading
Yellow
Open
(infinite)
Green
Open
(infinite)
and follow the steps listed.
Figure 167
3. Motor/generator controller (mounted to motor/generator
assembly)
431
Connector Graphic
g035728