Fault 6: Key Start Timeout - Toro Reelmaster 5010-H Diagnostic Manual

Fault 6: Key Start Timeout

InfoCenter Display:
Fault Description
The ignition switch was held in the S
starting function.
Note:
The operator can rotate the ignition switch to the O
switch to the S position again.
TART
Circuit Description
The ignition (key) switch has 3 positions: O
arm. The TEC-5002 monitors the operation of the ignition switch.
Conditions for Setting the Fault
If the ignition switch is in the S
more than 30 seconds, this fault is reported.
Important:
The key may have been intentionally held in the S
because the operator is having trouble starting the engine. Refer to the Starting Problems table in the
Electrical System chapter of the 5010-H Service Manual.
Note:
After 30 seconds of engine cranking, the TEC-5002 output to the start relay is de-energized even if the
ignition switch is kept in the S
Recommended Service Actions
Step 1: Verify that the fault repeats.
1. Clear the system faults from the InfoCenter. Refer to
2. Operate the machine.
Pass The fault did not repeat. Go to
Note:
If the fault does not repeat, an isolated event has occurred.
Fail The fault repeated. Go to Step 2.
Step 2: Cycle the ignition switch.
Turn the key to the O
FF
Note:
Do not allow the starter to spin for more than 30 seconds.
_____FAULT
position for more than 30 seconds, so the TEC-5002 disabled the
TART
, O
FF
position and the TEC-5002 controller senses the start signal is energized for
TART
position. This prevents overheating of the starter motor.
TART
Returning the Machine to Service (page 22)
position, and then attempt to start the engine again.
#6_____
Timeout
/P position, and then try rotating the ignition
N REHEAT
/P , and S
N REHEAT TART
TART
Clearing Faults from the InfoCenter (page
46
. The switch is located on the control
position for more than 30 seconds
and follow the steps listed.
21).