Toro Reelmaster 5010-H Diagnostic Manual page 82

1. Connector P03 (Down switch)
Pass The joystick switches tested good. Go to Step 3.
Fail
The joystick switches did not test good. Replace the failed joystick switches as needed. Go to
Returning the Machine to Service (page 22)
Step 3: Test the joystick circuit wiring.
1. Use a multimeter to test the resistance between the following pairs of locations:
Location Harness
1
Seat
2 Seat
1 Seat
2 Seat
2. Repair or replace defective wiring as needed. Go to
follow the steps listed.
Figure 55
Connector Pin
P04 1
(Ground)
P04 2
P03 1
(Ground)
P03 2
2. Connector P04 (Up switch)
and follow the steps listed.
Wire Expected
Color Reading
Black
Open
Pink/
Blue
Black
Open
Orange/
White
Returning the Machine to Service (page 22)
82
Connector Graphic
and
g033101