Toro Reelmaster 5010-H Diagnostic Manual page 307

Hide thumbs Also See for Reelmaster 5010-H:

Table of Contents

Use the Toro DIAG software to reprogram the machine in accordance with Toro DIAG User's Guide. The

replacement cutting reel motor is programmed during the reprogramming of the machine.

Disconnect the Toro DIAG cable from the machine.

Install the access panel onto the outer cover of the control arm.

Returning the Machine to Service (page 22)

Component Location and Electrical Connections

Cutting reel motor 5 is located in the front, right position. There are 2 electrical connections to the cutting reel

motor: P44 (4 wire) and P45 (2 wire).

and follow the steps listed.

Troubleshooting