Toro Reelmaster 5010-H Diagnostic Manual page 250

Hide thumbs Also See for Reelmaster 5010-H:

Table of Contents

The resistance tests passed, but the voltage readings in Step 8 are still bad.

Do not go to Step 10 until after the voltage readings in Step 8 are good.

One or more of the power and ground wiring tests failed. Repair or replace the worn or damaged

parts. Go to

Returning the Machine to Service (page 22)

Step 10: Test the CAN bus wiring in main harness connector P44.

Use a multimeter to test the resistance between the following pairs of locations:

Repair or replace any worn or damaged parts. Go to

follow the steps listed.

Component Location and Electrical Connections

Cutting reel motor 5 is located in the front, right position. There are 2 electrical connections to the cutting reel

motor: P44 (4 wire) and P45 (2 wire).

Chassis ground

Chassis ground

and follow the steps listed.

Returning the Machine to Service (page 22)

Connector Graphic

Troubleshooting