Table of Contents
Advertisement
After you set the PIN code, rotate the key switch to
the O
position and back to the O
FF
and save this feature.
Note:
Rotate the key switch to the O
then to the O
position to lock the protected menu.
N
Setting the Machine Configuration Passcode
You can set a passcode on the InfoCenter so that an
operator cannot access specific InfoCenter screens
without it. Refer to
Understanding the InfoCenter
Menu Items (page 21)
are passcode-protected.
1.
From the S
ETTINGS
S
.
ETTINGS
2.
Set P
S
ROTECT
ETTINGS
3.
When prompted, enter a 4-digit passcode.
4.
Turn the ignition key to the O
the code.
Note:
If you forget the user defined passcode,
you can obtain a temporary passcode from your
authorized Toro distributor.
Understanding the Fault-Log Indicator
If a fault occurs, a fault code appears on the
InfoCenter screen and a red flashing light appears
above the screen.
The fault is stored in a log entry located in the F
menu, which you or your distributor can use to identify
the issue that prompted the fault.
For a list of faults, refer to the Service Manual or your
authorized Toro distributor.
Main-Power Connectors
Before you charge the machine, work on the machine,
or install, remove, or work on the cutting units,
disconnect the machine from the power supply by
raising the connector cover and separating the
main-power connectors
base of the roll bar on the left side of the traction unit.
Plug the connectors together before operating the
machine.
position to enable
N
position and
FF
for the InfoCenter screens that
menu, select P
ROTECT
to O
.
N
position to save
FF
(Figure
23), located at the
1. Main-power connectors
2. Connector cover
CAUTION
If you do not disconnect the power to the
AULTS
machine, someone could accidentally turn on
the machine, causing serious bodily injury.
Always separate the connectors before
working on the machine.
Specifications
Refer to
Figure 24
Table (page 24)
weight.
Note:
Specifications and design are subject to
change without notice.
23
Figure 23
and the
Traction-Unit Specifications
for traction-unit dimensions and
g389175
Advertisement
Table of Contents
