Positioning The Seat - Toro 30487TC Operator's Manual

the engine; the engine should not crank. Repeat for
other motion-control lever.
3. Sit on the seat, engage the parking brake, move the
PTO switch to the O
motion-control levers to the N
Start the engine. While the engine is running, release
the parking brake, engage the PTO, and rise slightly
from the seat; the engine should stop within 2 seconds.
4. Without an operator on the seat, engage the parking
brake, move the PTO switch to the O
move the motion-control levers to the N
position. Start the engine. While the engine is running,
center either motion control; the engine should stop
within 2 seconds. Repeat for the other motion-control
lever.
5. Without an operator on the seat, disengage the parking
brake, move the PTO switch to the O
move the motion-control levers to the N
position. Try starting the engine; the engine should
not crank.
Using the SCM to Diagnose System
Problems
The machine is equipped with a standard control module
(SCM) monitoring system that tracks the function of various
key systems. The SCM is located under the right control
panel. Access it through the side panel cover
To open the side panel cover, release the 2 latches and pull
out on it.
1. Side panel cover
On the face of the SCM are 11 LEDs that illuminate
to indicate various system conditions. You can use 7 of
these lights for system diagnosis. Refer to
description of what each light means. For details on using the
position, and move the
FF
-
EUTRAL LOCK
position, and
FF
EUTRAL
position, and
FF
EUTRAL
(Figure
Figure 14
2. Latches
Figure 15
rest of the SCM functions, refer to the Service Manual, available
through your Authorized Toro Distributor.
position.
-
LOCK
1. High temperature shutdown—the engine temperature has
exceeded safe levels and the engine has been shut down.
- Check the cooling system.
LOCK
2. High temperature warning—the engine temperature is
approaching unsafe levels and the mower deck has been
shut down. Check the cooling system.
3. Operator is in the seat.
4. The PTO is on.
5. The parking brake is not engaged.
6. Controls are in neutral.
7. The SCM is receiving power and is operational.
14).

Positioning the Seat

1. Back-rest knob
2. Seat-suspension knob
for a
22
Figure 15
Figure 16
3. Lumbar-support-adjustment
knob
4. Seat-position-adjustment
lever