Attachments/Accessories; Operation; Check Crankcase Oil - Toro 07360 Operator's Manual

Dimensions (cont'd.)
Tongue weight 200 lbs.
Tow Capacity
Maximum trailer weight 1,500 lbs.
Ground Clearance 7" w/ no load
Wheel Base 70"
Wheel Tread (center Front 46"
Rear 47.7"
line to center line)
Height 75" to top of ROPS

Attachments/Accessories

A selection of Toro approved attachments and
accessories are available for use with the machine to
enhance and expand its capabilities. Contact your
Authorized Service Dealer or Distributor or go to
www.Toro.com for a list of all approved attachments
and accessories.

Operation

Note: Determine the left and right sides of the
machine from the normal operating position.
Before servicing or making adjustments to the
machine, stop engine, set parking brake and
remove key from the switch. Any load material
must be removed from bed or other attachment
before working under raised bed. Never work
under a raised bed without positioning safety
support on a fully installed cylinder rod.

Check Crankcase Oil

Service Interval: Before each use or daily
After the first 50 hours
Every 150 hours
The engine is shipped with approximately 3.5 quarts
(w/ filter) of oil in the crankcase; however, level of oil
must be checked before and after the engine is first
started.
Note: The best time to check the engine oil is when
the engine is cool before it has been started for the
day. If it has already been run, allow the oil to drain
back down to the sump for at least 10 minutes before
checking. If the oil level is at or below the "add" mark
on the dipstick, add oil to bring the oil level to the "full"
mark. DO NOT OVERFILL. If the oil level is between
the "full" and "add" marks, no oil addition is required.
1. Position machine on a level surface.
2. Remove dipstick and wipe it with a clean rag. Insert
dipstick into tube and make sure it is seated fully.
Remove dipstick and check level of oil.
23