Premaintenance Procedures; Using Bed Safety Support - Toro 07360 Operator's Manual

Only qualified and authorized personnel shall be permitted to maintain, repair, adjust or inspect
the vehicle.
Avoid fire hazards and have fire protection equipment present in the work area. Do not use an open
flame to check level or leakage of fuel, battery electrolyte or coolant. Do not use open pans of fuel
or flammable cleaning fluids for cleaning parts.
Many of the subjects covered in this maintenance section require raising and lowering the bed. The following
precautions must be taken or serious injury or death could result.
Before servicing or making adjustments to the machine, stop engine, set parking brake and remove
key from ignition switch. Any load material must be removed from bed or other attachment before
working under raised bed. Never work under a raised bed without positioning safety support on a
fully installed cylinder rod.
After maintenance is completed, remove safety support, slide it onto storage stud and lower bed.
Premaintenance
Procedures

Using Bed Safety Support

1. Raise bed until lift cylinders are fully extended.
2. Remove bed support from storage brackets on back
of ROPS panel (Figure 37).
Figure 37
1. Bed support
3. Push bed support onto cylinder rod, making sure
support end tabs rest on end of cylinder barrel and
on cylinder rod end (Figure 38).
1. Bed support
2. Cylinder barrel
4. To store bed support, remove bed support from
cylinder and insert into brackets on back of ROPS
panel.
5. Always install or remove bed support from outside
of bed.
Do not try to lower bed with bed safety support
on cylinder.
38
Figure 38
3. Bed