Hydraulic System Maintenance; Changing Transaxle / Hydraulic Fluid; Replacing Hydraulic Filter - Toro 07360 Operator's Manual

Figure 75
1. Parking brake lever
2. Knob
4. Tighten set screw after adjustment has been attained.
5. Install rubber grip onto parking brake lever.
3. Set screw
Hydraulic System
Maintenance
Changing Transaxle /
Hydraulic Fluid
Service Interval: After the first 10 hours
Every 800 hours
1. Position the vehicle on a level surface, stop engine,
engage the parking brake and remove key from
ignition switch.
2. Remove drain plug from side of reservoir and let
hydraulic fluid flow into drain pan. Reinstall and
tighten plug when hydraulic fluid stops draining.
Note: Clean the hydraulic strainer. Refer to
Cleaning Hydraulic Strainer.
1. Hydraulic reservoir
3. Fill reservoir with approximately 7.5 qt. of Dexron
IIl ATF. Refer to Checking Hydraulic Fluid.
4. Start engine and operate to fill hydraulic system.
Recheck oil level and replenish, if required.
Important: Use only hydraulic fluids specified.
Other fluids could cause system damage.

Replacing Hydraulic Filter

Service Interval: After the first 10 hours
Every 800 hours
Important: Use of any other filter may void the
warranty on some components.
1. Position vehicle on a level surface, stop engine,
engage the parking brake and remove key from
ignition switch.
2. Clean area around filter mounting area. Place drain
pan under filter and remove filter.
53
Figure 76
2. Drain plug