Adding Rear Ballast; Installing The Eu Decal; Installing The Eu Guard Kit - Toro 04384 Operator's Manual

(Figure 12, Figure 13, and
outward to raise and inward to lower. Tighten the jam
nut after the proper height is obtained.
8. Rotate the transport plate until it locks the pull frame.
Tighten the screws.
11

Adding Rear Ballast

Parts needed for this procedure:
Rear weight kit, Part No. 100-6442 (purchase
1
separately)
18 kg
Calcium chloride (purchase separately)
(40 lb)
Rear weight kit, Part No. 99-1645 (purchase
1
separately)
Procedure
This unit complies with the ANSI B71.4-2004 and EN ISO
5395:2013 when it is equipped with a rear weight kit, part
no. 100-6442 and 18 kg (40 lb) of calcium chloride ballast is
added to the rear wheel. If a 3–wheel drive kit is installed on
the machine, use rear weight kit, part no. 99-1645 instead, and
18 kg (40 lb) of calcium chloride.
Important: If a puncture occurs in a tire with calcium
chloride, remove the unit from the turf area as quickly
as possible. To prevent possible damage to the turf,
immediately soak the affected area with water.
12

Installing the EU Decal

Parts needed for this procedure:
1 Warning decal 121-2641
Procedure
If using this machine in the EU, affix the warning decal
121-2641 over English warning decal 121-2640.
Figure 14). Rotate the screw
13

Installing the EU Guard Kit

Parts needed for this procedure:
CE guard kit, Part No. 04441 (purchase seperately)
Procedure
This unit complies with EN ISO 5395:2013 when it is
equipped with a CE guard kit.
20