Adding Rear Ballast; Installing The Ce Guard Kit; Installing The Ce Decals - Toro Greensmaster 3250-D Operator's Manual

11

Adding Rear Ballast

Parts needed for this procedure:
Rear Weight Kit (Part No. 100-6442 or Part No.
1
99-1645; purchase separately)
18 kg
Calcium chloride (purchase separately)
(40 lb)
Procedure
This unit complies with EN ISO 5395:2013 and ANSI
B71.4-2017 when it is equipped with one of the
following:
•
Rear Weight Kit (Part No. 100-6442) and 18 kg
(40 lb) of calcium chloride ballast added to the
rear wheel
•
Rear Weight Kit (Part No. 99-1645) and 18 kg (40
lb) of calcium chloride (if a 3-Wheel Drive Kit is
installed on the machine)
Important:
If a puncture occurs in a tire with
calcium chloride, remove the machine from the
turf area as quickly as possible. To prevent
possible damage to the turf, immediately soak the
affected area with water.
12

Installing the CE Guard Kit

Parts needed for this procedure:
1
CE Guard Kit (Part No. 04441; purchase separately)
Procedure
Install the CE Guard Kit (Part No. 04441); refer to the
kit Installation Instructions.
This machine complies with EN ISO 5395:2013 when
it is equipped with the guard kit.
13

Installing the CE Decals

Parts needed for this procedure:
1 Warning decal (Part No. 136-8505)
1 CE mark decal
Procedure
If you use this machine in a country that complies to
CE standards, perform the following steps after you
install the weight kit and guard kit to the machine:
•
Apply the CE warning decal (Part No. 136-8505)
over the existing warning decal (Part No.
136-8506); refer to
1. Warning decal (Part No. 136-8506)—apply CE warning
decal (Part No. 136-8505) here.
•
Apply the CE mark decal next to the serial plate
(Figure 17).
17
Figure 16.
Figure 16
g235881