Toro Greensmaster 3250-D Operator's Manual page 35

on the dipstick, add oil to bring the oil level to the F
mark. Do not overfill.
Important:
Keep the engine oil level between the
upper and lower limits on the oil gauge; the engine
may fail if you run it with too much or too little oil.
1. Park the machine on a level surface, shut off the
engine and remove the key.
2. Remove the dipstick and wipe it with a clean rag
(Figure 34).
Important:
Remove the dipstick while filling
the engine with oil. When adding engine
oil or filling oil, there must be clearance
between the oil fill device and the oil fill
hole in the valve cover as shown in
33. This clearance is necessary to permit
venting when filling, which prevents oil from
overrunning into breather.
Figure 33
1. Note clearance
ULL
Figure
1. Filler cap
3. Push the dipstick into the tube and make sure it
is seated fully.
4. Remove the dipstick from the tube and check
the level of oil.
Note:
from the valve cover and slowly add enough
oil to raise the level to the F
dipstick.
g016415 Add the oil slowly and check the level often
during this process. Do not overfill.
5. Replace the dipstick.
6. Start and run the engine at idle for 30 seconds,
then shut the engine off. Wait 30 seconds, then
repeat steps
7. Install the filler cap and dipstick firmly in place.
Changing the Engine Oil and Filter
Service Interval: After the first 50 hours
Every 150 hours
1. Remove the drain plug
flow into a drain pan. When the oil stops, install
the drain plug.
35
Figure 34
2. Dipstick
If the oil level is low, remove the filler cap
ULL
2 through 5.
(Figure
g016419
mark on the
35) and let the oil