Lubrication; Greasing The Machine - Toro Greensmaster 3250-D Operator's Manual

Lubrication

Greasing the Machine

Service Interval: Every 50 hours (Also, apply grease
after every washing.)
The machine has grease fittings that must be
lubricated regularly with No. 2 general-purpose,
lithium-base grease. If the machine is operated under
normal conditions, lubricate all bearings and bushings
after every 50 hours of operation. Lubricate fittings
immediately after every washing, regardless of the
interval listed.
The following machine bearings and bushings must
be lubricated:
•
Rear wheel hub (1)
Figure 28
•
Castor bearing (1)
•
Steering cylinder (2)
•
Lift arms (3) (Figure
Figure 29
(Figure 28)
(Figure 28)
(Figure 28)
29)
•
Traction pedal pivot (1)
•
Carrier frame pivot (3)
g008439
1. Wipe the grease fitting clean so foreign matter
cannot be forced into the bearing or bushing.
2. Pump grease into the bearing or bushing.
3. Wipe up excess grease.
4. Apply grease to the reel motor spline shaft and
onto the lift arm when the cutting unit is removed
for service.
5. Apply a few drops of SAE 30 engine oil or spray
lubricant (WD 40) daily to all pivot points after
cleaning.
g008440
Note:
Refer to the Cutting Unit Operator's Manual for
cutting unit lubrication requirements.
33
(Figure 30)
Figure 30
(Figure 31)
Figure 31
g008441
g016483