Mounting The Seat - Toro Greensmaster 3250-D Operator's Manual

Media and Additional Parts
Description
Operator's Manual
Engine owner's manual
Declaration of Conformity
Noise rating certificate
Ignition keys
Note:
Mounting fasteners for the Greensmaster
3250-D cutting units are included with the cutting units.
1

Mounting the Seat

Parts needed for this procedure:
1 Seat
4 Nut (5/16 inch)
Procedure
Note:
Mount the seat slides in the front set of
mounting holes to gain an additional 7.6 cm (3 inches)
in the forward adjustment, or in the rear mounting
holes for an additional 7.6 cm (3 inches) in the
rearward adjustment.
1. Remove the locknuts securing the seat slides to
the shipping base straps. Discard the locknuts.
2. Connect the wire harness to the seat switch.
3. Secure the seat slides to the seat support with
the locknuts (5/16 inches) supplied in the loose
parts (Figure 3).
Qty.
1 Review it before operating the machine.
1 Use it to reference engine information.
1
For CE compliance
1
2 Start the engine.
1. Seat support
10
Use
Figure 3
2. Seat slide
g008408