Toro Greensmaster 3250-D Operator's Manual page 16

Figure 13
1. Transport plate
2. Adjusting screw
3. Transport-plate mounting
screw
3. On cutting units equipped with a chain link or
a straight lift hook
insets), verify that the distance from the top of
the carrier frame adjusting screw to the back
of the carrier frame is 22 mm (7/8 inch). If the
distance is not 22 mm (7/8 inch), proceed to step
4. If the cutting unit is equipped with an offset lift
link (Figure 13), proceed to the next step.
Figure 14
1. Transport plate
2. Adjusting screw
3. Transport-plate mounting
screw
4. Offset lift hook
5. 25 mm (1 inch)
(Figure 14 and Figure 15
4. Chain link
5. 22 mm (7/8 inch)
g008423
1. Transport plate
2. Adjusting screw
3. Transport —late mounting
screw
4. Loosen the transport plate mounting screws
(Figure 14,
5. Raise the cutting units to the transport position.
Important:
the transport position when the reel motors
are in the machine-frame holders. Damage
to the motors or hoses could result.
6. Ensure that each carrier frame is at the same
height from the ground. If they are, proceed to
step 8.
7. If the carrier frames are not at the same height,
loosen the jam nut on the carrier frame adjusting
screw (Figure
Rotate the screw outward to raise and inward to
lower. Tighten the jam nut after you obtain the
proper height.
8. Rotate the transport plate until it locks the pull
frame. Tighten the screws.
g008421
16
Figure 15
4. Link hook
5. 22 mm (7/8 inch)
Figure 15, and Figure
Do not raise the suspension to
13, Figure 14, and
g008422
13).
Figure 15).