Table of contents
8.1.6
8.1.7
Tapping (CYCLE84, 840).......................................................................................................... 300
8.1.8
8.1.9
8.1.9.1
Approach/retraction................................................................................................................... 310
8.1.10
8.1.10.1 Function..................................................................................................................................... 311
8.1.11
8.1.12
8.1.13
8.1.14
Repeating positions................................................................................................................... 322
8.1.14.1 Function..................................................................................................................................... 322
8.2
Rotate........................................................................................................................................ 323
8.2.1
General...................................................................................................................................... 323
8.2.2
Stock removal (CYCLE951) ...................................................................................................... 323
8.2.3
Groove (CYCLE930) ................................................................................................................. 327
8.2.4
8.2.5
8.2.6
Thread turning (CYCLE99) ....................................................................................................... 336
8.2.7
Thread chain (CYCLE98).......................................................................................................... 346
8.2.8
Cut-off (CYCLE92) .................................................................................................................... 349
8.3
Contour turning ......................................................................................................................... 351
8.3.1
General information................................................................................................................... 351
8.3.2
8.3.3
Creating a new contour ............................................................................................................. 354
8.3.4
Creating contour elements ........................................................................................................ 356
8.3.5
8.3.6
Changing the contour................................................................................................................ 364
8.3.7
8.3.8
Stock removal (CYCLE952) ...................................................................................................... 366
8.3.9
8.3.10
Plunge-cutting (CYCLE952)...................................................................................................... 374
8.3.11
8.3.12
Plunge-turning (CYCLE952) ..................................................................................................... 380
8.3.13
8.4
Milling ........................................................................................................................................ 386
8.4.1
Face milling (CYCLE61)............................................................................................................ 386
8.4.2
8.4.3
Circular pocket (POCKET4) ...................................................................................................... 394
8.4.4
8.4.5
Circular spigot (CYCLE77)........................................................................................................ 404
8.4.6
Multi-edge (CYCLE79) .............................................................................................................. 408
8.4.7
8.4.8
8.4.9
Open groove (CYCLE899) ........................................................................................................ 420
8.4.10
8.4.11
Thread milling (CYCLE70) ........................................................................................................ 430
8.4.12
Engraving (CYCLE60)............................................................................................................... 434
8.5
Contour milling .......................................................................................................................... 442
8.5.1
General information................................................................................................................... 442
14
Operating Manual, 02/2012, 6FC5398-8CP40-3BA0
Turning