7.18
Example: Standard machining
General information
The following example is described in detail as ShopTurn program. A G code program is
generated in the same way; however, some differences must be observed.
If you copy the G code program listed below, read it into the control and open it in the editor,
then you can track the individual program steps.
Tools
The following tools are saved in the tool manager:
Roughing tool_80
Roughing tool_55
Finishing tool
Plunge cutter
Threading tool_2
Drill_D5
Miller_D8
Adapt the cutting data to the tools used and the specific application conditions at the
machine.
Blank
Dimensions: ∅90 x 120
Material: Aluminum
Turning
Operating Manual, 02/2012, 6FC5398-8CP40-3BA0
Machine manufacturer
Under all circumstances, observe the machine manufacturer's instructions.
80°, R0.6
55°, R0.4
35°, R0.4
Plate width 4
∅5
∅8
Creating a ShopTurn program
7.18 Example: Standard machining
261