Measuring Cycle Support; Example: Standard Machining - Siemens SINUMERIK 828D Operating Manual

Creating a ShopTurn program

8.17 Measuring cycle support

8.17 Measuring cycle support
Measuring cycles are general subroutines designed to solve specific measurement tasks.
They can be adapted to specific problems via parameter settings.
References
You will find a more detailed description on how to use measuring cycles in:
Programming Manual Measuring cycles / SINUMERIK 840D sl/828D
8.18

Example: Standard machining

General information
The following example is described in detail as ShopTurn program. A G code program is
generated in the same way; however, some differences must be observed.
If you copy the G code program listed below, read it into the control and open it in the editor,
then you can track the individual program steps.
Tools
The following tools are saved in the tool manager:
Roughing tool_80
Roughing tool_55
Finishing tool
Plunge cutter
Threading tool_2
Drill_D5
Miller_D8
Adapt the cutting data to the tools used and the specific application conditions at the
machine.
Blank
Dimensions: ∅90 x 120
Material: Aluminum
272
Software option
You require the "Measuring cycles" option to use "Measuring cycles".
Machine manufacturer
Under all circumstances, observe the machine manufacturer's instructions.
80°, R0.6
55°, R0.4
35°, R0.4
Plate width 4
∅5
∅8
Operating Manual, 01/2015, 6FC5398-8CP40-5BA2
Turning