Siemens SINUMERIK 828D Operating Manual page 305

Parameter Description
Machining
Single position
•
position
Drill hole at programmed position.
Position pattern
•
(only for G code)
Position with MCALL
DIR Direction of rotation
•
•
(only for G code)
Z0 (only for G Reference point Z
code)
Machining
Face C
•
surface
Face Y
•
Peripheral surface C
•
(only for Shop-
Peripheral surface Y
•
Turn)
Position
At the front (face)
•
(only for Shop-
At the rear (face)
•
Turn)
Outside (peripheral surface)
•
Inside (peripheral surface)
•
Clamp/release spindle
The function must be set up by the machine manufacturer.
(only for Shop-
Turn)
Z1 Drilling depth (abs) or drilling depth in relation to Z0 (inc)
DT
Dwell time at final drilling depth in seconds
•
Dwell time at final drilling depth in revolutions
•
SPOS Spindle stop position
Lift mode
Do not lift off contour
•
The cutting edge is not fully retracted, but traverses back to the safety clearance in
rapid traverse.
Lift
•
The cutting edge is retracted from the hole edge and then moved back to the retrac-
tion plane.
DX (only G Code) Retraction distance in the X direction (incremental) - (for lift-off only)
DY (only G code) Retraction distance in the Y direction (incremental) - (for lift-off only)
DZ (only G code) Retraction distance in the Z direction (incremental) - (for lift-off only)
D (only Shop- Retraction distance (incremental) - (for lift only)
Turn)
Turning
Operating Manual, 01/2015, 6FC5398-8CP40-5BA2
Programming technology functions (cycles)
9.1 Drilling
Unit
mm
mm
s
rev
Degrees
mm
mm
mm
mm
305