Siemens SINUMERIK 828D Operating Manual page 40

Introduction
2.3 Machine control panels
Traversing axes with rapid traverse override and coordinate switchover
...
...
Spindle control with override switch
Feed control with override switch
40
Axis keys
Selects an axis.
Direction keys
Select the traversing direction.
<RAPID>
Traverse axis in rapid traverse while pressing the direction key.
<WCS MCS>
Switches between the workpiece coordinate system (WCS) and machine
coordinate system (MCS).
<SPINDLE STOP>
Stop spindle.
<SPINDLE START>
Spindle is enabled.
<FEED STOP>
Stops execution of the running program and shuts down axis drives.
<FEED START>
Enable for program execution in the current block and enable for ramp-up
to the feedrate value specified by the program.
Operating Manual, 01/2015, 6FC5398-8CP40-5BA2
Turning