Machining the workpiece
5.10 Editing a program
Setting
Automatic save (only
local and external
drives)
Cut only after select-
ing
Determine pro-
cessing times
Saving machining
times
Display cycles as
machining step
Font size
Note
All entries that you make here are effective immediately.
Precondition
You have opened a program in the editor.
154
Meaning
Yes: The changes are saved automatically when you change to another
•
operating area.
No: You are prompted to save when changing to another operating area.
•
Save or reject the changes with the "Yes" and "No" softkeys.
Yes: The cutting of program sections is possible only when program lines
•
have been selected, i.e. the "Cut" softkey only then is active.
No: The program line, in which the cursor is positioned, can be cut out
•
without having to select it.
Defines which program runtimes are determined in the simulation:
Off
•
Block by block: The runtimes are determined for each program block.
•
Non-modal: The runtimes are determined at the NC block level.
•
After the simulation, the required processing times are displayed in the editor.
Specifies how the machining times determined are processed.
Yes
•
A subdirectory with the name "GEN_DATA.WPD" is created in the directo-
ry of the part program. There, the machine times determined are saved in
an ini file together with the name of the program.
No
•
The machining times that have been determined are only displayed in the
editor.
Yes: The cycle calls in the G code programs are displayed as plain text.
•
No: The cycle calls in the G code programs are displayed in the NC syn-
•
tax.
Defines the font size for the editor and displaying the program sequence.
Operating Manual, 01/2015, 6FC5398-8CP40-5BA2
Turning