Siemens SINUMERIK 828D Operating Manual page 613

Displaying/hiding a multi-channel view
...
See also
Setting the multi-channel view (Page 615)
Turning
Operating Manual, 01/2015, 6FC5398-8CP40-5BA2
1. Select the "Machine" operating area
2. Select the "JOG", "MDA" or "AUTO" mode.
3. Press the menu forward key and the "Settings" softkey.
4. Press the "Multi-channel view" softkey.
5. In the window "Settings for Multi-Channel View" in the selection
box "View", select the required entry (e.g. "2 channels") and de-
fine the channels as well as the sequence in which they are to be
displayed.
In the basic screen for the "AUTO", "MDA" and JOG" operating
modes, the upper window of the left-hand and right-hand channel
columns are occupied by the actual value window.
6. Press the "T,F,S" softkey if you wish to view the "T,F,S" window.
The "T,F,S" window is displayed in the lower window of the left-
hand and right-hand channel column.
Note:
The "T,F,S" softkey is present only for smaller operator panels,
i.e. up to OP012.
Multi-channel machining
10.1 Multi-channel view
613