Siemens SINUMERIK 828D Operating Manual page 485

Parameters in the "Input complete" mode
Parameters, G code program
Input
PL Machining plane
Milling direction
RP Retraction plane
SC Safety clearance
F Feedrate
Parameter
Machining
surface
(only for ShopTurn)
Position
(only for ShopTurn)
(only for ShopTurn)
Machining
FZ (only for G code)
Circular pattern
Turning
Operating Manual, 01/2015, 6FC5398-8CP40-5BA2
Complete
•
mm
mm
*
Description
Face C
•
Face Y
•
Peripheral surface C
•
Peripheral surface Y
•
At the front (face)
•
At the rear (face)
•
Outside (peripheral surface)
•
Inside (peripheral surface)
•
Clamp/release spindle (only for end face Y/peripheral surface Y)
The function must be set up by the machine manufacturer.
∇ (roughing)
•
∇∇∇ (finishing)
•
∇∇∇ edge (edge finishing)
•
Chamfering
•
Depth infeed rate
Full circle
•
The circumferential slots are positioned around a full circle. The distance from
one circumferential slot to the next circumferential slot is always the same and
is calculated by the control.
Pitch circle
•
The circumferential slots are positioned around a pitch circle. The distance
from one circumferential slot to the next circumferential slot can be defined us-
ing angle α2.
Programming technology functions (cycles)
Parameters, ShopTurn program
T Tool name
D Cutting edge number
F Feedrate
S / V Spindle speed or constant cut-
ting rate
9.4 Milling
mm/min
mm/tooth
rpm
m/min
Unit
*
485