Siemens SINUMERIK 828D Operating Manual page 413

Procedure
Parameters, G code program
PRG Name of the program to be generated
PL Machining plane
RP Retraction plane
SC Safety clearance
F Feedrate
CON Name of the updated blank contour for
residual material machining (without the
attached character "_C" and double-
digit number)
Residual With subsequent residual material re-
material moval
Yes
•
No
•
CONR Name to save the updated unmachined-
part contour for residual material re-
moval - (only "Yes" for residual material
removal)
Parameters Description
Machining
•
•
Machining
•
direction
•
•
The machining direction depends on the stock removal direction and choice of tool.
Turning
Operating Manual, 01/2015, 6FC5398-8CP40-5BA2
1. The part program or ShopTurn program to be processed has been cre-
ated and you are in the editor.
2. Press the "Contour turning" softkey.
3. Press the "Stock removal residual material" softkey.
The "Stock removal residual material" input window opens.
mm
mm
*
∇ (roughing)
∇∇∇ (finishing)
Face
•
Longitudinal
•
Parallel to the contour
•
•
Programming technology functions (cycles)
Parameters, ShopTurn program
T Tool name
D Cutting edge number
F Feedrate
S / V Spindle speed or constant cutting
rate
From inside to outside
From outside to inside
From end face to rear side
From rear side to end face
9.3 Contour turning
mm/rev
rpm
m/min
Unit
413