Siemens SINUMERIK 828D Operating Manual page 223

Parameter Description
Data for Selection of the spindle for the blank
Main spindle
•
Counterspindle
•
Note:
If the machine does not have a counterspindle, then the entry field "Data for" is not appli-
cable.
Mirroring Z Mirroring of the Z axis - (only for "data for counterspindle")
Yes
•
Mirroring is used when machining on the Z axis
No
•
Mirroring is not used when machining on the Z axis
Blank Selecting the blank
Centered cuboid
•
Tube
•
Cylinder
•
Polygon
•
Delete
•
ZA Initial dimension
ZI Final dimension (abs) or final dimension in relation to ZA (inc)
ZB Machining dimension (abs) or machining dimension in relation to ZA (inc)
Spindle chuck
Yes
•
data
You enter spindle chuck data in the program.
No
•
Spindle chuck data are transferred from the setting data.
Note:
Please observe the machine manufacturer's instructions.
Spindle chuck
Only chuck
•
data
You enter spindle chuck data in the program.
Complete
•
You enter tailstock data in the program.
Note:
Please observe the machine manufacturer's instructions.
Jaw type Selecting the jaw type of the counterspindle. Dimensions of the front edge or stop edge -
(only if spindle chuck data "yes")
Jaw type 1
•
Jaw type 2
•
ZC4 The main spindle chuck dimensions - (only for spindle chuck data "yes")
ZS4 Stop dimension of the main spindle - (only for spindle chuck data "yes")
ZE4 Jaw dimension of the main spindle for jaw type 2 - (only for spindle chuck data "yes")
Turning
Operating Manual, 01/2015, 6FC5398-8CP40-5BA2
Creating a G code program
7.6 Blank input
Unit
mm
mm
mm
mm
mm
mm
223