Siemens SINUMERIK 828D Operating Manual page 86

Computerized numerical controller for machine tools

Hide thumbs Also See for SINUMERIK 828D:

Table of Contents

Setting up the machine

3.6 Measuring the workpiece zero

Settable zero offsets

The labeling of the softkeys for the settable zero offsets varies, i.e. the settable zero offsets

configured on the machine are displayed (examples: G54...G57, G54...G505, G54...G599).

Please refer to the machine manufacturer's specifications.

Select "JOG" mode in the "Machine" operating area.

Press the "Workpiece zero" softkey.

The "Set Edge" window opens.

Select "Measuring only" if you only want to display the measured val-

Select the desired zero offset in which you want to store the zero point

(e.g. basis reference).

Press the "Zero offset" softkey and select the zero offset in which the

zero point is to be saved in the "Zero Offset – G54 ... G599" window

that opens and press the "In Manual" softkey.

You return to the "Set Edge" window.

Traverse the tool in the Z direction and scratch the workpiece.

Enter the position setpoint of the workpiece edge Z0 and press the "Set

ZO" softkey.

Operating Manual, 01/2015, 6FC5398-8CP40-5BA2

Sinumerik 840d sl