Channel view
3-channel view
4-channel view
Displaying functions
Channel view
3-channel view
4-channel view
3-channel view /
4 channel view
Toggling between the channels
Turning
Operating Manual, 01/2015, 6FC5398-8CP40-5BA2
Display in the "Machine" operating area
The following windows are displayed one above the other for each channel:
Actual value window
•
T,F,S window
•
Block display window
•
The following windows are displayed one above the other for each channel:
Actual value window
•
T,S,F window
•
G functions (the "G functions" softkey is omitted)
•
Block display window
•
Display in the "Machine" operating area
Selection using vertical softkeys:
The T,F,S window is overlaid by pressing one of the vertical softkeys.
•
The window showing the G codes is overlaid if you press one of the verti-
•
cal softkeys.
Selection using horizontal softkeys:
The block display is overlaid if you press the "Overstore" horizontal softkey
•
The block display is overlaid by pressing the softkey "block search".
•
The window is shown as a pop-up if you press the "Prog. control" softkey.
•
If you press one of the horizontal softkeys in the "JOG" operating mode
•
(e.g. "T,S,M", "Meas. tool", "Positions" etc.), then you change into the sin-
gle-channel view.
Press the <CHANNEL> key to toggle between the channels.
Press the <NEXT WINDOW> key to toggle within a channel column
between the three or four windows arranged one above the other.
Multi-channel machining
10.2 Multi-channel support
623