Machining Plane, Milling Direction, Retraction Plane, Safe Clearance And Feedrate (Pl, Rp, Sc, F) - Siemens SINUMERIK 828D Operating Manual

7.7 Machining plane, milling direction, retraction plane, safe clearance and feedrate (PL, RP, SC, F)

7.7 Machining plane, milling direction, retraction plane, safe clearance
and feedrate (PL, RP, SC, F)
In the program header, cycle input screens have general parameters that always repeat.
You will find the following parameters in every input screen for a cycle in a G code program.
Parameter Description
PL Each input screen has a selection box for the planes, if the planes have not been speci-
fied by NC machine data.
Machining plane:
G17 (XY)
•
G18 (ZX)
•
G19 (YZ)
•
Milling direction When machining a pocket, a longitudinal slot or a spigot, the machining direction (climb-
- only for mill- ing or conventional) and the spindle direction are taken into account in the tool list. The
ing pocket is then machined in a clockwise or counter-clockwise direction.
During path milling, the programmed contour direction determines the machining direc-
tion.
RP Retraction plane (abs)
During machining the tool traverses in rapid traverse from the tool change point to the
return plane and then to the safety clearance. The machining feedrate is activated at
this level. When the machining operation is finished, the tool traverses at the machining
feedrate away from the workpiece to the safety clearance level. It traverses from the
safety clearance to the retraction plane and then to the tool change point in rapid trav-
erse.
The retraction plane is entered as an absolute value.
Normally, reference point Z0 and retraction plane RP have different values. The cycle
assumes that the retraction plane is in front of the reference point.
SC Safety clearance (inc)
The safety clearance specifies from which clearance to the material rapid traverse is no
longer used.
The direction in which the safety clearance is active is automatically determined by the
cycle. Generally, it is effective in several directions. The safety clearance must be en-
tered as an incremental value (without sign).
F Feedrate
The feedrate F (also referred to as the machining feedrate) specifies the speed at which
the axes move when machining the workpiece. The unit of the feedrate (mm/min,
mm/rev, mm/tooth etc. ) always refers to the feedrate type programmed before the cycle
call.
The maximum feedrate is determined via machine data.
Turning
Operating Manual, 01/2015, 6FC5398-8CP40-5BA2
Creating a G code program
Unit
mm
mm
225