Siemens SINUMERIK 828D Operating Manual page 465

Parameter Description
Peripheral surface Y: The positions refer to the reference point:
C0 Positioning angle for machining surface – (only for single position)
Y0 Reference point Y – (only for single position)
Z0 Reference point Z – (only for single position)
X0 Reference point X – (only for single position)
(only for Shop-
Turn)
∅ Diameter of spigot
Z1 Spigot depth (abs) or depth relative to Z0 or X0 (inc) - (only for ∇ and ∇∇∇)
DZ Maximum depth infeed - (only for ∇ and ∇∇∇)
UXY Plane finishing allowance for the length (L) and width (W) of the circular spigot.
Smaller circular spigot dimensions are obtained by calling the cycle again and pro-
gramming it with a lower finishing allowance. - (only for ∇ and ∇∇∇)
UZ Depth finishing allowance (tool axis) - (only for ∇ and ∇∇∇)
∅1 Diameter of blank spigot (important for determining approach position) - (only for ∇ and
∇∇∇)
FS Chamfer width for chamfering - (for chamfering only)
ZFS Insertion depth of tool tip (abs or inc) - (for chamfering only)
(ZFS for machining surface, face C/Y or XFS for peripheral surface C/Y)
* Unit of feedrate as programmed before the cycle call
Parameters in the "Input simple" mode
G code program parameters
Input
Milling direction
RP Retraction plane
F Feedrate
Turning
Operating Manual, 01/2015, 6FC5398-8CP40-5BA2
simple
•
mm
*
Programming technology functions (cycles)
ShopTurn program parameters
T Tool name
D Cutting edge number
F Feedrate
S / V Spindle speed or constant
cutting rate
9.4 Milling
Unit
Degrees
mm
mm
mm
mm
mm
mm
mm
mm
mm
mm
mm
mm/min
mm/rev
rpm
m/min
465