Simulating machining
6.9 Editing and adapting a simulation graphic
+
6.9
Editing and adapting a simulation graphic
6.9.1
Enlarging or reducing the graphical representation
Precondition
The simulation or the simultaneous recording is started.
Procedure
...
210
Press the <CTRL> and <S> keys simultaneously to enable and disable
the single block mode.
1.
Press the <+> and <-> keys if you wish to enlarge or reduce the graphic
display.
The graphic display enlarged or reduced from the center.
- OR -
Press the "Details" and "Zoom +" softkeys if you wish to increase the
size of the segment.
- OR -
Press the "Details" and "Zoom -" softkeys if you wish to decrease the
size of the segment.
- OR -
Press the "Details" and "Auto zoom" softkeys if you wish to automatical-
ly adapt the segment to the size of the window.
The automatic scaling function "Fit to size" takes account of the largest
expansion of the workpiece in the individual axes.
Operating Manual, 01/2015, 6FC5398-8CP40-5BA2
Turning