Siemens SINUMERIK 828D Operating Manual page 147

Note
Replacing texts
• Read-only lines (;*RO*)
If hits are found, the texts are not replaced.
• Contour lines (;*GP*)
If hits are found, the texts are replaced as long as the lines are not read-only.
• Hidden lines (;*HD*)
If hidden lines are displayed in the editor and hits are found, the texts are replaced as
long as the lines are not read-only. Hidden lines that are not displayed, are not replaced.
See also
Editor settings (Page 153)
Turning
Operating Manual, 01/2015, 6FC5398-8CP40-5BA2
5. Press the "OK" softkey to start the search.
If the text you are searching for is found, the corresponding line is high-
lighted.
6. Press the "Replace" softkey to replace the text.
- OR -
Press the "Replace all" softkey to replace all text in the file that corre-
sponds to the search term.
- OR -
Press the "Continue search" softkey if the text located during the search
should not be replaced.
- OR -
Press the "Cancel" softkey when you want to cancel the search.
Machining the workpiece
5.10 Editing a program
147