Siemens SINUMERIK 828D Operating Manual page 339

Parameter
LAB
(only for G code)
PL
(only for G code)
Axes
(only for G code)
Machining
surface
(only for ShopTurn)
Position
(only for ShopTurn)
Coordinate
system
(only for ShopTurn)
X0
Y0
X1 ...X8
Y1 ...Y8
(only for G code)
Z0
C0
Z1 ... Z8
C1 ...C8
(only for G code)
Turning
Operating Manual, 01/2015, 6FC5398-8CP40-5BA2
Description
Repeat jump label for position
Machining plane
Selection of the participating axes
XY (1st and 2nd axis of the plane)
•
ZC (rotary axis and assigned linear axis)
•
YZC (rotary axis and both axes of the plane)
•
Note:
Rotary axes are only displayed in the selection field if they have
been released for use in the position pattern.
Please observe the information provided by your machine manufac-
turer.
Face C
•
Face Y
•
Face B
•
Peripheral surface C
•
Peripheral surface Y
•
At the front (face)
•
At the rear (face)
•
Outside (peripheral surface)
•
Inside (peripheral surface)
•
Right-angled or polar
•
Dimensions in right-angled coordinates or polar coordinates (on-
ly for face C and face Y)
Right-angled or cylindrical
•
Dimensions in right-angled coordinates or cylindrical coordinates
- (only for peripheral surface C)
Axes XY (at right angles)
X coordinate of 1st position (abs)
Y coordinate of 1st position (abs)
X coordinate for additional positions (abs or inc)
Y coordinate for additional positions (abs or inc)
Axes ZC (for G19)
Z coordinate of 1st position (abs)
C coordinate of 1st position (abs)
Z coordinates for additional positions (abs or inc)
C coordinates for additional positions (abs or inc)
Programming technology functions (cycles)
9.1 Drilling
Unit
mm
mm
mm
mm
mm
Degrees
mm
Degrees
339