Siemens SINUMERIK 828D Operating Manual page 328

Programming technology functions (cycles)
9.1 Drilling
Parameter Description
SDE Direction of rotation after end of cycle:
(only for G code)
•
•
•
Technology Adapting the technology:
Yes
•
–
–
–
–
No
•
Note:
The technology fields are only displayed if their display has been enabled.
Please observe the information provided by your machine manufacturer.
Exact stop (only
Empty: Behavior the same as it was before the cycle was called
•
for technology,
G601: Block advance for exact stop fine
•
yes)
G602: Block advance for exact stop coarse
•
G603: Block advance if the setpoint is reached
•
Precontrol (only
Empty: Behavior the same as it was before the cycle was called
•
for technology,
FFWON: with precontrol
•
yes)
FFWOF: without precontrol
•
Acceleration (only (only in mode "without compensating chuck")
for technology,
Empty: Behavior the same as it was before the cycle was called
•
yes)
SOFT: Jerk-limited (soft) acceleration of the axes
•
BRISK: Abrupt acceleration of the axes
•
DRIVE: Reduced axis acceleration
•
Spindle (only for (only in mode "without compensating chuck")
technology, yes)
Speed controlled: Spindle for MCALL: Speed-controlled mode
•
Position controlled: Spindle for MCALL: Position-controlled operation
•
328
Exact stop
Precontrol
Acceleration
Spindle
Operating Manual, 01/2015, 6FC5398-8CP40-5BA2
Unit
Turning