Siemens SINUMERIK 828D Operating Manual page 499

Parameter
Machining
Technology
X0
Y0
Z0
(only for G code)
X0 or L0
Y0 or C0
Z0
(only for ShopTurn)
CP
X0 or L0
Y0 or C0
Z0
(only for ShopTurn)
Y0 or C0
Z0
X0
(only for ShopTurn)
Turning
Operating Manual, 01/2015, 6FC5398-8CP40-5BA2
Description
∇ (roughing)
•
∇∇∇ (pre-finishing)
•
∇∇∇ (finishing)
•
∇∇∇ base (base finishing)
•
∇∇∇ edge (edge finishing)
•
Chamfering
•
Vortex milling
•
The milling cutter performs circular motions along the length of the slot and
back again.
Plunge cutting
•
Sequential drilling motion along the tool axis.
Milling direction - (except plunge cutting)
Climbing
•
Conventional
•
Climbing-conventional milling
•
The positions refer to the reference point:
Reference point X
Reference point Y
Reference point Z
Face C: The positions refer to the reference point:
Reference point X or reference point length polar
Reference point Y or reference point angle polar
Reference point Z
Face Y: The positions refer to the reference point:
Positioning angle for machining area
Reference point X or reference point length polar
Reference point Y or reference point angle polar
Reference point Z
Peripheral surface C: The positions refer to the reference point:
Reference point Y or reference point angle polar
Reference point Z
Cylinder diameter ∅
Programming technology functions (cycles)
9.4 Milling
mm
mm
mm
mm
mm or
degrees
mm
Degrees
mm
mm or
degrees
mm
mm or
degrees
mm
mm
499