License Terms - Siemens G120P Technical Manual

BOP-2 - screen symbols

4.3 License terms

Siemens
Building Technologies
Function Status
Command Manual
source
Variable speed Ready
drive
state
JOG function Active
Fault or alarm Fault or
display alarm
Table 6: BOP-2 screen symbols
The variable speed drive contains open source software (OSS). The license terms
for the open source code are stored in the variable speed drive.
Transferring the license terms
To transfer the OSS license terms from the variable speed drive to a PC, proceed
as follows:
1. Switch off the variable speed drive power supply.
2. Insert an empty memory card into the card slot of the variable speed drive.
3. Switch on the variable speed drive power supply.
4. When you have switched on the power supply, wait 30 seconds. During this
time, the device writes the "Read_OSS.ZIP" file onto the memory card.
5. Switch off the variable speed drive power supply.
6. Remove the card from the device.
7. Use a card reader to import the file to a PC.
For information about firmware upgrade and downgrade options, please go to
http://support.automation.siemens.com/WW/news/en/67364620.
Symbol Comments
No symbol is displayed if AUTO mode is activated.
Static symbol, does not rotate.
Is displayed if the JOG function is activated.
● Flashing symbol:
– A command is active.
– The variable speed drive stops. Clear the fault.
● Non-flashing symbol:
– There is an alarm (e.g., overtemperature).
– The variable speed drive keeps running.
Product information
4
License terms
27 | 98
A5E36496664A_d
2016-03-17