Sony DVS-9000 User Manual page 126

1
2
3
Making DME GPI output settings
Use the following procedure.
1
2
3
4
126
Setup Relating to DME
In the DME>Device Interface menu, select the action to be set, and press
[H/L Set].
The H/L Set menu appears.
Using any of the following methods, select the settings.
• Press directly on the list appearing in the status area.
• Press the arrow keys to scroll the reverse video cursor.
• Turn knob 1 to make the setting.
Knob Parameter
1 No
To apply the selection made in step 2 when the input is high, press [H Set].
To apply the selection made in step 2 when the input is low, press [L Set].
This confirms the setting, which appears in the status area.
In the DME>Device Interface menu, press [DME1 GPI Output].
The DME1 GPI Output menu appears.
The output port selection is fixed at 1.
In the <Trigger Type> group, select the trigger polarity.
Status: Depending on the status, the relay contacts are closed or opened,
or the output is switched between high and low.
No Operation: The trigger has no effect on the relay state or output level.
Using any of the following methods, select the action you want to set.
• Press directly on the list appearing in the status area.
• Press the arrow keys to scroll the reverse video cursor.
• Turn knob 2 to make the setting.
Knob Parameter
2 Action
a) Error Make, Error Break, No Action
Press [Action Set] to confirm the action selection.
The selected setting appears in the status area.
Adjustment
Signal format/screen aspect ratio
selection
Adjustment
Action selection
Setting values
1 to ...
Setting values
a)
1 to ...