Sony DVS-9000 User Manual page 65

3
Using any of the following methods, select the register you want to create
(or edit).
• In the status area, press the [No] or [Name] for the shot box register you
want to select, then press [EDIT].
• Use knob 1 to specify the register, and press [Edit].
Knob Parameter
1 Shotbox Reg
The Shotbox>Register>Store/Recall>Edit menu appears, and it is now
possible to make the settings for the specified register.
You can also use knob 1 to select the register in this menu.
In the status area, the shot box register status for each region appears.
4
To select the desired region, press on the region name in the status area.
5
In the <Assign> group, select the snapshot or effect to be allocated to the
region.
[Snapshot]: Allocate a snapshot register.
[Effect]: Allocate a keyframe effect.
6
Depending on the selection in step 5, set the parameters as follows.
• When a snapshot is selected
Knob Parameter
2 Snapshot
• When an effect is selected
Knob Parameter
2 Effect
a) For the DME region, you can also set register numbers 101 to 199, 201 to 299, and 301 to
399.
7
To run the allocated effect as soon as it is recalled, press [Auto Run],
turning it on.
8
Repeat steps 4 to 7 as required.
9
In the <Store> group, press [Store], to save the setting.
Note
"GPI" and "Router" are not executed even if set.
Adjustment
Shot box register number
Adjustment
Snapshot register number
Adjustment
Keyframe effect number
Setting values
1 to 99
Setting values
1 to 99
Setting values
a)
1 to 99
Shot Box Register Creation
65