Sony DVS-9000 User Manual page 88

2
3
To set a link table
For the link selected in the External Bus Link menu, make the settings as
follows.
1
2
3
88
Setup Relating to Operations From the Control Panel
Using any of the following methods, define the position of the matrix to be
linked.
• Press directly on the list appearing in the status area.
• Press the arrow keys to scroll the reverse video cursor.
• Turn the knobs to make the setting.
Knob Parameter Adjustment
2 Source Source start address
3 Destination Destination start address
4 Level Level
To confirm a source address selected in step 2, press [Source Set], to
confirm a destination address press [Destination Set], and to confirm a
level press [Level Set].
This confirms the selection, which is reflected in the status area.
In the Panel>Config>External Bus Link>Link Matrix Adjust menu, press
[Link Table Adjust].
The Link Table Adjust menu appears.
The status area lists the status of the currently selected link, combinations
of video signals and sources, and the sources that can be selected.
Using any of the following methods, select what the setting applies to.
• Press directly on the list appearing in the status area.
• Press the arrow keys to scroll the reverse video cursor.
• Turn the knobs to make the selection.
Knob Parameter Adjustment
1 Main No Internal video signal selection
2 Source No Matrix source selection
To confirm the source selected in step 2, press [Link Source Set].
This confirms the selection, which is reflected in the status area.
To initialize the set source
Press [Init Link Table].
A confirmation message appears.
Press [Yes].
Setting values
1 to 897
1 to 897
1 to 8
Setting values
1 to 128
1 to 128