Sending Documents via Telephone Line
Redialing
Automatic Redialing
If a busy line is detected, the machine will redial the number up to 5
times at 3 minutes interval. However, if a busy line is not detected, the
machine will redial only one time. During that time, a message will
appear as shown to the right.
A file number is shown in the upper right hand corner of the display if it
is a memory transmission file.
Manual Redialing
You can also redial the last dialed number manually by pressing
To redial the last dialed number through memory
1
Make sure that the MEMORY lamp is on.
2
PAUSE
REDIAL
3
START
The document is stored into memory with a file number.
Then dials the last dialed number.
To redial the last dialed number through ADF
1
2
MEMORY
3
PAUSE
REDIAL
Your machine starts dialing the last dialed number.
(see Note 1)
Note:
1. While the unit is displaying "WAIT TO DIAL", you can press
106
Set document(s) face down.
Set document(s) face down.
Make sure that the lamp goes off.
START
WAIT TO DIAL
(Telephone number)
key.
REDIAL
ENTER STATION(S)
THEN PRESS START 00%
TEL. NO.
5551234
* STORE *
PAGES=001
* DIALING *
5551234
ENTER STATION(S)
THEN PRESS START 00%
ENTER STATION
PRESS START TO DIAL
5551234
* DIALING *
5551234
to start redialing immediately.
REDIAL
NO.001
NO.001
01%
NO.002
00%