Panasonic KX-TD500 Features Manual page 161

Conditions
WARNING
The software contained in ARS feature to allow user access to the network must be
upgraded to recognize newly established network area codes and exchange codes as they
are placed into service.
Failure to upgrade the premises PBXs or peripheral equipment to recognize the new
codes as they are established will restrict the customer and the customer's employees
from gaining access to the network and to these codes.
KEEP THE SOFTWARE UP-TO-DATE WITH THE LATEST DATA.
• Tenant Service
ARS mode can be turned on / off on a tenant basis.
• Toll Restriction
Toll Restriction check is performed before ARS is applied.
• Dialing Plan
ARS works according to the selected dialing plan. Thus, if the dialed number is not found
in the dialing plan (Leading Digits Table), the CO call is made by "Trunk Access, Idle"
(Automatic Line Access) feature.
• ARS Override
ARS is not applied to a call made by pressing the G-CO or S-CO button.
• This feature also applies to a call forwarded by "Call Forwarding - to Trunk" feature.
• If a call is made by using a memory dialing (Redial, One-Touch Dialing, Station / System
Speed Dialing, Call Log, Outgoing) a dial tone is not sent to the extension user.
• If the Inter-digit time (fixed to 15 seconds) expires while making an outgoing call with
ARS, the system will select a CO line on a Local Access basis and return CO dial tone or
reorder tone is sent to the caller. This is determined by System Programming <Section 2.8
System Option, "59. ARS Call Timeout Mode" in the Programming Guide>.
Programming Guide References
• 2.2 Tenant
– Automatic Route Selection
• 2.3 Numbering Plan
– Local CO Line Access / ARS
• 2.8 System Option
– ARS Call Timeout Mode
• 7.2 Time Table
• 7.3 Leading Digits Table
• 7.4 Routing Plan
• 7.5 Digits Modification Table
Features Guide References
1.6 Originating Features
• Trunk Access
Features Guide
General Features
161