Replacing The Charge Wire - Toshiba 1550 Service Manual

9.3.6 Transfer/separation chargers
(1) Pull out the cassette.
(2) Remove the knob for the cleaning-pad shaft.
(3) After opening the front cover, remove the hook
and then take out the entire unit.
Note: When reinstalling the transfer/separation
charger, be sure to fit it into the rear terminal
guide. Since the charger is pushed up by a
spring, make sure that it moves up and down
freely.

Replacing the charge wire:

(Entire length: 353 mm; tungsten wire: 0.06 mm
dia.)
• Disengage the claw of the transfer entrance
guide from the rear side.
• Remove the front and rear terminal covers.
For the separation charger, remove the sup-
porter in addition.
Note: For replacing the cleaning pad, the same
procedure as for the main charger applies.
1550/1560 DRUM
Hook
Transfer entrance guide
Terminal cover
9 - 6
Knob
Cassette
Transfer/separation
charger
Terminal cover
Supporter
Mar. 1998 © TOSHIBA