Table of Contents
Advertisement
3.3 Site Survey
The section describes how to perform the site survey by using CSs. This is done by starting up a CS with DIP
switch settings as the following table, and then starting up another CS in the same state to synchronize with
the first CS. During this synchronization, the color of the second CS's LED changes according to the radio
signal strength level. This can be used as a guide to position the CS.
DIP switch settings
SW
SW5
SW6
Note
Site Survey by using also PS can be performed.
For details, refer to "5.5 Site Survey by Using PS".
Setting and Installing a CS Temporarily for Site Survey
Perform the procedure in "Setting and Installing a CS Temporarily" to position the CS at the temporary position.
Testing the Radio Signal Strength
1.
Press and release the RESET switch on the first CS.
The LED will flash red and green alternately.
2.
Move the second CS near the first CS until the LED of the second CS turns green ON.
3.
Repeat steps 1 and 2 for all other CSs.
For details about the LED status of the second CS and all other CSs, see the following table.
LED status during site survey
Green
ON
Slow Flashing
Amber
ON
Red
ON
Checking the coverage area by using PS
If necessary, check the coverage area and handover operation by using PS.
For details about checking the coverage area by using PS, refer to "5.5.3 Measuring the Signal Strength".
LAN Synchronization
OFF
ON
Color
Radio Signal Strength
Good
Unreliable
Bad
Signal lost
3 Deployment Procedure
Air Synchronization
ON
ON
Installation Guide
21
Hide quick links:
Advertisement
Table of Contents
