Registering The Unit To The Pbx - Panasonic kx-ns0154la Installation Manual

3 Deployment Procedure

3.4 Registering the unit to the PBX

When installing the unit at the same site as the PBX, connect the unit to the LAN and turn it on.
Connecting the Unit to the LAN
When connecting the unit to the LAN, connect it to a switching hub.
Note
•
Use an Ethernet straight cable with an RJ45 connector to connect the CS to a switching hub. The cable
should be a 10 BASE-T/100 BASE-TX CAT 5 (Category 5) or higher cable, and the diameter of the
cable must be 6.5 mm (1/4 in) or less.
•
It is possible to connect the CS to the LAN while registering the CS to the PBX.
1.
Connect the cable to the unit.
2.
Pass the cable through the groove of the unit.
3.
Connect the other end of the cable to the switching hub.
Connecting the AC Adaptor to the Unit
This unit complies with the IEEE 802.3af Power-over-Ethernet (PoE) standard. If PoE is available on your
network, this unit can receive the necessary power from the network through the Ethernet cable. In this case,
no AC adaptor is needed.
However, if PoE is not available, you will need to connect an AC adaptor to the unit.
Note
Only use a compatible AC adaptor (optional). For details, refer to "Optional Accessories".
1.
Connect the AC adaptor cord to the unit.
2.
Pass the cord through the groove of the unit.
3.
Connect the AC adaptor to an AC outlet.
Registering the unit to the PBX
(Full Automatic Mode)
If networking settings have been completed, when the unit is connected to the same network as the PBX, it
will be registered automatically. No registration procedure is required.
(Manual Mode)
After connecting the unit to the PBX over a network, register the unit to the PBX manually.
For details about the registration procedure in manual mode, refer to "5.9 Registering IP Cell Stations to the
KX-NS series PBX".
Note
The PBX's default setting of the synchronization method is LAN synchronization. If air synchronization is
used, change the this setting before registering the unit to the PBX.
(LAN synchronization only)
The unit that is registered to the PBX is assigned to LAN Sync Group No.1 .
If no Master CS is configured, the first CS assigned to LAN Sync Group becomes Master CS automatically.
22 Installation Guide