ABB 800xA Operation page 136

HXAM_G_Faceplate
Figure 64. BOPS Info Tab
training. Some of the tolerance values are used by logic to determine the nearest of
all BOPS to the COPS.
Last calculated Training period
When all the BOPS go stale or when you press the "Clear BOPS and Retrain"
button, the Asset Monitor will go to training mode. The training period is calculated
by the Asset Monitor and displayed. The Asset Monitor will try to find all the
expected number of BOPS sets till the training period is elapsed. If the Asset
Monitor is able to find the required number of BOPS before the training period is
elapsed, then it shall come out of training.
The calculated training period and training tolerance band values will be displayed,
if the Asset Monitor has gone to training at least once since it was last loaded to AO
server.
136
Section 9 Heat Exchanger Asset Monitor (HXAM)
TC08485A
3BUA000150-600