ABB 800xA Operation page 162

HXAM_ST_Faceplate
Figure 73. Mass FlowTab
The fields in the Mass Flow tab are:
•
162
Mass Flow Hot Monitor:
– Status: This field gives the status of the Mass Flow Hot Monitor. The
status values are:
Enabled:
Not Enabled:
Stale Data in Trained Set: If one or more BOPS is stale.
Not Available:
– Limit Reached: Gives the subcondition for the W_Hot_Operating_Point
condition. The different subconditions that will be reported during
Monitoring are:
Normal:
Increasing:
Section 9 Heat Exchanger Asset Monitor (HXAM)
TC08468A
If Mass Flow Hot Monitor is enabled.
If Mass Flow Hot Monitor is not
enabled.
During Training.
Mass Flow Hot is within the Normal
range.
Mass Flow Hot has crossed the
W_ Hot _Increasing Limit.
3BUA000150-600