Sharp AR-FX2 Service Manual page 10

AR-FX2
14) Attach the FAX PWB.
G Fix it with (9) M3 screw (gold) packed together with the FAX expan-
sion kit.
15) Attach the motherboard. (packed together with the LCD panel kit)
G As shown in the figure, tilt the part (electrolytic capacitor) on the
MCU PWB, connect the connector from the machine, insert the con-
nectors, and fix with M3 screw (gold).
16) Remove the left cabinet from the copier.
G Remove the screw, remove the screw for securing the second and
third mirrors, and then remove the left cabinet.
17) Attach the speaker harness.
G Attach the speaker to the left side cabinet using the
supplied M3 screws (gold color)(8), and then secure the speaker cable
using the harness securing tape included in the FAX expansion kit.
Securing tape
3 – 3
18) Attach the left cabinet to the copier.
G Attach the left cabinet using the screw, then pass the speaker har-
ness through the hole of the PWB mounting frame and connect the
speaker harness to the connector of the copier.
Speaker harness
Note: Take care so that the speaker harness does not become caught
between the corner frame and the left cabinet.
19) Attach the TEL/LIU PWB.
G Attach the TEL/LIU PWB to the PWB mounting frame using the sup-
plied M3 screws (gold color)(9), and then connect the TEL/LIU PWB
and FAX PWB using the FFC harness.
Note: Before attaching the FFC harness, release the connector lock
and insert the cable. After attaching, lock the connector.
20) Attach the shield plate.
G Attach with the screw.
M3x6
M3 x 8 for steel
Caution
Blue line(To the right)
M3X6
M3X6